Asynchronous
Serial Tx Controller and Rx Monitor
The USBee LX Digital Test Pod Tx and Rx Serial modules turn your LX pod into a full duplex asynchronous serial port (1 start bit, 8 data bits, 1 stop bit).
The TX Controller module allows you to send digital asynchronous data out the pod Signal 3. The data can come from the keyboard (to send ASCII bytes) or from a data file. The data that is sent is displayed in either ASCII or hex representation. Baud rates are also selectable including 125k, 57.6k, 28.8k, 19.2k, 9600 and 4800 baud.
The Rx Monitor module allows you to receive and display digital asynchronous data from the pod Signal 2. The data received can be saved to an output file for further processing by third party software. The data that is received is displayed in either ASCII or hex representation. Baud rates are also selectable including 125k, 57.6k, 28.8k, 19.2k, 9600 and 4800 baud.
The Tx and Rx modules can be run independently or together depending on your testing needs.
|
|
|
|
|
|
|
|
|
Copyright(c) 2003 CWAV. All rights reserved.
support@usbee.com